Air compressor fault solution
Exhaust temperature ：
1Ambient temperature rise, ventilation environment temperature48c° below
2If the oil level is low, add lubricating fluid.
3The oil cooler is blocked, and the cooler is cleaned.
43. If the oil filter is blocked, replace the oil filter.
53. The temperature control valve core is blocked, replace the temperature control valve.
62. The yin-yang rotor of the main engine is worn, and maintenance is recommended.
Low exhaust pressure:
12. If the air filter is blocked, replace the air filter.
23. The minimum pressure valve is stuck or broken, replace it for maintenance.
32. The oil is blocked, and it is recommended to replace the oil
12. If the safety valve is defective, disassemble, check and replace the repair kit.
2Failure of pressure gauge, replacement
After the screw air compressor is installed and debugged, the general factory runs almost 24 hours a day except for maintenance. At this time, if the air compressor is of poor quality or fails due to improper operation, it will make people feel upset, which will not only increase the use cost, but also affect the production process. In this article, Emerdy Xiaobian will introduce how to judge and eliminate the oil leakage failure of the screw air compressor.
Kerosene penetration method: the inspection process is to wipe the body and cylinder head with cotton yarn head soaked with kerosene first, then wipe the places where cracks may occur with dry cotton yarn head and kerosene, and immediately put white powder on the map of these places. at this time, where there are cracks, kerosene will penetrate into the white powder, and the location and length of the cracks will be clearly displayed.